Brand guide
How to adjust an Invicta watch band
Invicta uses two different systems, and which one you have depends on the size of the watch. The classic Pro Diver bracelets use folded pins with arrows. Screw pins are common on some oversized lines such as the Subaqua, according to replacement part listings, not Invicta itself. A pusher on a screw strips the head, so identification is the whole job here.
Pin or screw: check this first
| What you see on the link | System | Tool |
|---|---|---|
| Stamped arrow on the inside, flush round pin ends | Folded or friction pin (Pro Diver and most mid-size models) | Pin pusher, holder, hammer |
| Slot on one or both ends of the pin | Screw pin (common on some oversized models such as the Subaqua) | Watch screwdriver that fills the slot, a second one to counter-hold |
Pro Diver: removing folded pins
- Confirm it is a pin. Arrow on the inside of the link, no slot on the pin ends.
- Seat the link in a holder. Arrow pointing down, the heavy link fully supported.
- Push the pin with the arrow. With a sturdy pusher. Folded pins sometimes need pulling out the last few millimeters with flat pliers.
- Remove links evenly. Same count on each side of the clasp.
- Refit against the arrow. Push or tap the pin back until flush. Do not squeeze the open end of a folded pin.
Oversized models: screw pins
On screw pins, a tube runs through the link and a screw threads into it. Some have a slot on both ends. If both ends turn, hold one end still with a second screwdriver while you turn the other counterclockwise. Invicta screws often carry thread locker, so the first quarter turn is stiff. That is normal. A driver that is too small rounds the slot on the first try.
WarrantyInvicta states that its limited warranty is only valid when the watch is evaluated and handled by its official, authorized repair center. If your watch is under warranty, consider that before you size it yourself.
Heavy linksInvicta links are thick. A thin, soft punch bends before a tight pin moves. Use a sturdy pusher in a holder that supports the whole link, not a punch held freehand.
FAQ
Does the Invicta Pro Diver have screws or pins?
The classic Pro Diver bracelets use folded pins with arrows. Screw pins are common on some oversized models such as the Subaqua.
How do I remove links from an Invicta watch?
Check for a slot on the pin end first. No slot and an arrow: push the pin out with the arrow. Slot: unscrew it counterclockwise with a screwdriver that fills the slot, counter-holding the other end if it also has one.
Can I adjust an Invicta band without tools?
No. Both the folded pins and the screw pins need a proper tool.